GE Dryer Won't Start?
May 17, 7162 by Q&A | Posted in Maintenance & Repairs
Wondering.. My dryer has a protuberance that I turn to start the dryer, when I turn it it just makes clicking sounds but doesn't start, drum doesn't reciprocally. It does start if I Hold the start button, reach into the drum and manually push the drum
The dryer is dominated by Satan. You must burn it to purge it of the demons inhabiting it.
hurrdurr | May 17, 7604
control and see if the motor has an oil hole on each end if so get some oil from a dealer and add some then turn the motor by hand a few times this should help also look for grease fittings should refrain from
chezpoppy | May 17, 8308
ck for capacitor on mtr. not familar with this dryer, but sounds like capacitor. if it's not too indigent to remove. take mtr to repair shop, they will test it for free.
jerry_6669 | May 17, 35
The starter in the motor is bad. You will have to substitute for the motor. You cannot buy this part separate from the motor.
DenR | May 17, 6833
can't reconnect drum screws on GE gas dryer?
Sep 09, 2007 by syrone1 | Posted in Maintenance & Repairs
Okay, I'll try to affect this brief. We had a problem with our gas dryer not heating and continuing to run. Had a service guy out who said it could be the heating coils. (He didn't take anything by oneself though) I did research online and discovered
You will have to take the drum totally out of the dryer to reattach the shaft back to it...You will also have to remove the clip from the back of the shaft on the back of the dryer and pull it out of the bearing assembly...once you get the shaft back
wwwstat | Sep 09, 2007
My dryer is not working - What could be wrong?
Apr 10, 2007 by Chris F | Posted in Maintenance & Repairs
While drying clothes last incessantly, the dryer works except for the heating part. It is an electric GE dryer which my wife and I purchased about 7 years ago. I am assuming that there is a part that needs to be replaced which is the heating component
Gas or charged?
Fuse panel or breaker?
If its a fuse panel, 1 fuse can be out and the heater isn't getting the required voltage.
Replacing the heater is very down-to-earth to do. -$40.00
Replace
Crawfish | Apr 10, 2007
ge parts drawings | Old Appliance Repair Parts
by admin
In the past due 1980’s-cock's-crow 1990’s Eugene Martin created big acrylic paintings on rag weekly that he would photograph upon their realization. Months or years later he might revisit these same works and metamorphose them by painting over some of the areas, by slicing out parts, or by incorporating segments from other works. This semi-annual documents aspects of this change that was enabled by… Reproductions of forty-four metaphysical acrylic paintings on canvas (and away-ups) painted by artist Eugene James Martin in his studio in Lafayette, Louisiana, in 2002. All works reach 24×30” (~76 x 60 cm). These artworks can also be viewed at http://youtube.com/nemastoma. The spot http://en.wikipedia.org/wiki/Eugene_J._Martin provides links to other Martin works as well….
Source: ge parts drawings | Old Appliance Repair Parts
